![]() This setting can be disabled when using headphones or analogue outputs. To keep AV Receivers awake, an inaudible random noise signal is sent. Note: Sounds can be missed if the system is slow in waking. Off- Audio output enters a suspended state.1-10 Minutes- Same as Always except the audio device will be allowed to sleep after the selected period expires.Always- Continuous inaudible signal is output which keeps the receiving audio equipment alive for any new sounds, however this might also block sound from other applications.Select the behaviour when no sound is required for either playback or GUI Sounds. This can occur when using 1.5x playback speed. When the speed change exceeds this threshold, a pitch correction filter will be applied to reduce the "chipmonk" effect of voices. Threshold for pitch correction Settings level: Medium & High- Uses progressively more system resources.Low- Is fast and will have minimal impact on system resources such as the use of the CPU.Select the quality of resampling for cases where the audio output needs to be at a different sampling rate from that used by the source. Select to enable upmixing of 2 channel audio to the number of audio channels specified by the Output Configuration setting above. Enable this if you find that the movie dialogues are very low. Note: Dynamic range is the difference between the quitest and loudest sounds. Disabled- Maintains the dynamic range of the original audio source when downmixed however the volume will be lower.Enabled- Maintains the volume level of the original audio source, however the dynamic range is compressed.Maintain original volume on downmix Settings level:ĭownmixing combines the Left, Right, Center, Left surround, and Right surround channels to drive stereo or mono speakers. Higher numbers for finer volume adjustments. This is the number of button presses to go from mute to full volume. Optimised - Output properties are set at the start of playback and will not change if the properties of the source change.Best Match - Output properties are set to always be as close a match to the source properties as possible.Fixed - Output properties are set to the specified sampling rate & speaker configuration at all times.Note: S/PDIF supports 2.0 channels only but can still output multichannel audio using a format supported by passthrough. This setting does not apply to passthrough audio. Select the number of channels supported by the audio connection, or the number of speakers if connected by analogue connections. This setting nominates which audio device Kodi should use. If you do not have an AVR or TV that can decode all audio stream formats then Kodi will decode the audio stream.Įven if you do have an AVR, not all audio can be sent via passthrough- eg flac, mp3, wav and other music files and AAC audio streams Select the device to be used for playback of decoded audio. Select your Audio device and configure it to match your audio system. If this is your first time adjusting the Audio Settings you may like to use the Audio Quick Start Guide. Some options change depending on which audio output device has been selected. The options shown in the images are from a Windows 10 installation and may differ from other hardware platforms. The settings chosen here can have a big impact on CPU load on lower powered hardware, so it is worth the time to understand the available options and how they should be configured. This page contains the options and settings to ensure your audio device functions correctly with Kodi. 1.5 Maintain original volume on downmix. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |